/Why should the Pcb factory set up the air shower door?
Air shower door is a kind of special equipment for clean and purifying. It is a special channel pipe card set for the printed circuit board assembly staff to enter the production workshop. The purpose of our air shower door is to effectively remove the printed circuit board assembly. The dust on the surface of employees and objects reduces the amount of dust brought into the workshop. At the same time, it functions as an airlock chamber, preventing the assembly of printed circuit boards from bringing hair, dust and bacteria into the workshop, achieving the strict dust-free purification standard of the circuit board workshop, and producing high-quality circuit board products.
Recently, the wind shower door has been paid attention to by our customers. Setting the wind shower door is also a requirement for our customers to produce quality.
Pcb assembly reflow soldering process requires that the pads of both chip components should be independent pads. When the pad is connected to a large-area ground wire, the cross-laying method and the 45 ° -laying method should be preferred; the wire drawn from the large-area ground wire or the po...
A very strange phenomenon has recently been discovered. Many companies are currently consulting with PCBA to manufacture this piece, some are very professional and some do not understand. It is equivalent to the South Pole and the North Pole. I roughly analyzed what might be because the current s...
Medical robots refer to the role of intelligent devices to replace some people. For example, surgical robots, rehabilitation robots, etc. Medical robots are essentially intelligent devices, but they can independently operate some plans through programs compiled by engineering personnel. For some ...